During the operation of the gas producer, strict attention should be paid to whether the gas producer and its auxiliary equipment, instruments, etc. are normal. If abnormalities are found, they should be repaired immediately.
After each ash discharge, it is necessary to decide whether to blast the furnace generally or locally according to the descent of the material layer and the ventilation situation. When the fire layer is uneven, drill the high part of the fire layer. When the ash layer is uneven, drill the high part of the ash layer. When slagging, brazing should be done immediately, and less brazing should be done when the furnace is normal.
The water vapor produced in the gas generator is a kind of combustible gas from the oxidized coal powder through the water vapor. Then the quality of the steam is determined by the quality of our production. In the gas generator, adjusting its water vapor condition has become an important point, which is a problem that everyone cannot ignore. So, how to adjust the water vapor in a two-stage gas producer?
First of all, we need to understand the effects of water vapor. When we add water vapor to the gas generator, if the amount of water vapor is too large, it will cause the coal gas raw materials inside to agglomerate. After agglomeration, it will seriously affect the output of gas, and its quality will frequently go wrong and gradually decline.
Since there are many kinds of raw materials used in the production of gas at present, the problem of raw materials, if we do not choose well, it will bring great harm. Therefore, we also need to choose good raw materials according to the specific raw materials. It is very important to choose good raw materials. of. Moreover, we have to determine the ratio of steam according to its raw materials, and the ratio of different raw materials will be different, which is affirmative.
